Measure and reconstruct a telecom tower
List the tower parts and measure each antenna. State whether directions are measured from the scene axes or a surveyed north reference.
What the previous work taught us
In an earlier CADground tower task, the scan showed a mast, supports, and antennas facing different directions. Each part needed its own inspection and measurements. Repeating one antenna model around the mast did not match the source.
The steps below use lessons from that task. Use your own scan to determine counts and dimensions. Agree the limits for each check. A fitted component does not prove that the full assembly passed review.
Prepare the source data
- A registered scan with enough views of the mast, antenna faces, and supports.
- Known units and the definition of ground/base elevation.
- Surveyed north or another orientation reference, if geographic bearings are required.
- The required inventory fields and any acceptance tolerance.
Keep the original scan. If an antenna’s top or far side is hidden, mark it as uncertain in the inventory. Do not fill the gap by copying another antenna.
1. Inventory before modeling
Inspect the tower from all useful sides. Look from above and below where the scan has data. List the mast, supports, and each visible antenna. Give each antenna a unique name based on its level and position. Do not assume equal spacing or identical tilt. Identify hidden parts before building geometry.
- Compare the inventory against the scan from opposite sides.
- Confirm component counts and distinguish supports from antenna bodies.
- Select separate source regions for nearby parts that overlap in one view.
- Agree a naming convention that remains stable in measurements, CAD, and reports.
2. Measure each antenna independently
Use each antenna’s own scan points to fit its front face and body. Report width, height, position from the stated datum, front-face direction, downtilt, and side lean. Show the source points used for each value. State what is uncertain. Do not copy angles from nearby antennas.
Before filling the table, define the reference axis and direction in which angles increase. The earlier task measured azimuth clockwise from scene +Y. This is a scene-relative angle. It is a true-north bearing only if the survey establishes how scene +Y relates to true north.
Identify the antenna’s front face. A surface normal is a line perpendicular to a face. If it points the wrong way, the reported direction can be wrong even when the angle is precise. Check it against a view of the actual antenna.
3. Reconstruct the structural parts
Use geometry that keeps the mast and support dimensions and axes clear. If the mast narrows with height, preserve that taper. A general mesh can join nearby parts and make them difficult to measure separately.
Reconstruct the scanned mast and supports as separate, named parts. Preserve the measured taper, member axes, and visible connections. Use supported analytic or simple fitted geometry. Mark hidden connections as unresolved. Do not fill them with an assumed standard tower pattern.
4. Check each part and the full assembly
- Show the scan and CAD together from the six main directions where useful.
- Inspect antenna edges, support connections, and separation between close objects.
- Measure how closely each fitted region matches the scan. Compare the result with the agreed tolerance.
- Record checks of individual parts separately from checks of the full assembly.
- List parts that failed, were not tested, or have too few source points for a check.
5. Create the inventory and report
| Field | Required context |
|---|---|
| Antenna ID / level | A consistent name linked to a labeled view. |
| Dimensions and position | Units, datum, source region, and any boundary added by inference. |
| Azimuth | Reference axis, direction of increasing angles, and whether the reference is local or surveyed. |
| Tilt and lean | Definitions, identified front face, and measurement uncertainty. |
| Fit status | The tolerance and part checked. State whether it passed, failed, or had too little evidence for a result. |
| Outputs | Measurement table, labeled views, report, and reviewed CAD export if requested. |
Report scan observations separately from engineering conclusions. Geometry alone does not confirm structural capacity, antenna performance, or installation compliance.